Categories

False alarms and system glitches can be exasperating, and even worse, might prevent your home security system from doing its job effectively. Thankfully, most issues, from dead batteries to false alarms, are straightforward to correct. Explore our suggestions for troubleshooting your home alarm system in Logan. We’ll help keep your family shielded and your system operating properly.

Test Your Home Security System In Logan

One sensible way to troubleshoot your property’s security is to test it yourself! Newer systems have a test mode so you don’t mistakenly prompt an emergency call. Once you’re in test mode, follow these steps:

• Activate your system as you normally would when going out.
• Open a window or door protected by a contact sensor, or try to set off another device. Shut the window or door so it doesn’t trip the alarm as you switch out of test mode.
• Let the alarm resonate for 60 seconds to make sure a transmission is dispatched to the security provider and an entry is created in the alarm system log.
• Proceed to test sensors as you wish
• Check the alarm’s activity log to validate functionality.

Rest assured, monitoring professionals can tell that your system is undergoing a test. Just be sure to switch out of test mode when you’re done. It’s a good idea to test every other month or anytime you make changes to your home’s internet or phone provider.

Evaluate The Positioning And State Of Motion Detectors

Although an crucial part of your alarm system, motion sensors are prone to false alarms. Do your part to prevent them with a few straightforward troubleshooting steps.

• Do a physical check. Is there anything that could move within range of the sensor, like a window treatment taken by a breeze?
• Is the sensor dirty? Dirt, cobwebs, and debris can result in poor performance. Check to confirm the face is clean.
• Does the motion detector have pet immunity you can activate? Some can be configured to ignore pets weighing up to 100 pounds.
• When was the battery replaced? Low batteries might affect performance or cause false alarms.
• Is a heat source affecting the sensor? Excess heat from direct sun or a fireplace can cause an alarm.

Keep Batteries Ready And Pay Attention To Low Battery Warnings

One helpful benefit of modern home security systems is that they’ll notify you when batteries are dying. If your system has a mobile app or control panel, you’ll often find alerts there. Depending on your system, you may detect an intermittent beep when batteries are getting low. 

Motion detectors, smoke detectors, contact sensors, and other wireless components have batteries that should be replaced every 1 to 2 years. It’s a good idea to keep batteries ready and set a replacement schedule. Top systems also include a rechargeable backup battery for the main control panel. This battery keeps your system operating if your power goes out and should charge back up once the electricity is working again. If it doesn’t, you will have to replace it.

Troubleshooting Is Easy With ADT Home Security In Logan 

As the leading name in home security, ADT builds systems that offer unrivaled functionality and protection. Switching to test mode is straightforward through the ADT+ app or MyADT.com, and you’ll always be sent notifications when a battery is low. Contact Secure24 Alarm Systems, an authorized ADT dealer, to learn more and design a system perfectly suited to your Logan home and family. Place a call to (435) 393-6672 or complete our form today!